On Mon, Aug 9, 2010 at 6:10 PM, Kyle R. Burton <kyle.burton@gmail.com> wrote:
> Hello,
>
> I'm new to the list and not even sure if this is the right place to be
> posting this...
>
> I've worked through the documentation for postgres 9.0 (beta2) and
> have successfully set up a master and hot slave configured with
> streaming replication (and xlog shipping). That configuration seems
> to be correctly updating the slave and the slave accepts read queries
> and shows up to date table data (based on testing by hand with some
> DDL and insert queries).
>
> Now that I have that successfully configured, I have manually
> performed a fail over by stopping the master, moving a virtual IP
> address from the master to the slave, and touched the trigger file on
> the slave. This worked as expected and the former slave promoted
> itself to being a full read/write master.
>
> I went through the process of failing back manually by dumping the
> database on the slave, restoring it on the master, moving the VIP back
> and renaming the recovery.done back to recovery.conf. This took some
> time and required several steps, but was also successful.
>
> After I had moved the VIP from the master to the slave, I had to
> restart (not just reload) the postgres daemon to get it to start
> listening on the new ip address (it was previously listening to
> another IP [10.x.x.y] on the same NIC [eth0]). I have the
> listen_addresses configured to listen on both an internal (10.x.x.y)
> address as well as the vip (10.x.x.z), but the interface on the slave
> did not have this ip address at the time Postgres was started (so I'm
> not all that surprised it didn't bind to that address on becoming the
> master).
>
> Is there any way to get PostgreSQL to bind to a new ip address and
> interface without actually shutting it down? If it could, would I
> need to break all the current (read only) client connections to get
> them to reconnect and have the ability to write? (am I confused about
> this?)
hm. I wonder if you could implement a solution around pgbouncer to do this...
merlin