Обсуждение: manual Installation for thread safety

In order to use the --enable-thread-safety build switch I need to do a manual build... UNLESS there is a way of doing this from the RPM command line, which I have not been able to find.  Where do I get 8.2.5-1?  This version came with my installation of Fedora 8 so I presume it is the version I should use to ensure complete compatibility with the other software on the system.

Thanks for your help!

--
Best Regards,
Lynn P. Tilby
Ph: 480 632-8635
unixprgrmr01@gmail.com

"unixprgrmr01@gmail.com" <unixprgrmr01@gmail.com> writes:
> In order to use the --enable-thread-safety build switch I need to do a
> manual build... UNLESS there is a way of doing this from the RPM command
> line, which I have not been able to find.

Uh ... whose RPM are you using?  All the PG RPMs I know of have been
built with --enable-thread-safety for quite a long time.  Certainly
the one that comes with Fedora 8 is.

            regards, tom lane

On Wed, 2008-07-09 at 12:51 -0700, unixprgrmr01@gmail.com wrote:
> In order to use the --enable-thread-safety build switch I need to do a
> manual build... UNLESS there is a way of doing this from the RPM
> command line, which I have not been able to find.

Did you install redhat-rpm-config RPM?

-HTH.
--
Devrim GÜNDÜZ
devrim~gunduz.org, devrim~PostgreSQL.org, devrim.gunduz~linux.org.tr
                   http://www.gunduz.org