Teach libpq to handle arbitrary-length lines in .pgpass files.
Historically there's been a hard-wired assumption here that no line of
a .pgpass file could be as long as NAMEDATALEN*5 bytes. That's a bit
shaky to start off with, because (a) there's no reason to suppose that
host names fit in NAMEDATALEN, and (b) this figure fails to allow for
backslash escape characters. However, it fails completely if someone
wants to use a very long password, and we're now hearing reports of
people wanting to use "security tokens" that can run up to several
hundred bytes. Another angle is that the file is specified to allow
comment lines, but there's no reason to assume that long comment lines
aren't possible.
Rather than guessing at what might be a more suitable limit, let's
replace the fixed-size buffer with an expansible PQExpBuffer. That
adds one malloc/free cycle to the typical use-case, but that's surely
pretty cheap relative to the I/O this code has to do.
Also, add TAP test cases to exercise this code, because there was no
test coverage before.
This reverts most of commit 2eb3bc588, as there's no longer a need for
a warning message about overlength .pgpass lines. (I kept the explicit
check for comment lines, though.)
In HEAD and v13, this also fixes an oversight in 74a308cf5: there's not
much point in explicit_bzero'ing the line buffer if we only do so in two
of the three exit paths.
Back-patch to all supported branches, except that the test case only
goes back to v10 where src/test/authentication/ was added.
Discussion: https://postgr.es/m/4187382.1598909041@sss.pgh.pa.us
Branch
------
master
Details
-------
https://git.postgresql.org/pg/commitdiff/b55b4dad99e99d5306744a4e8ef8021fa3a922e4
Modified Files
--------------
src/interfaces/libpq/fe-connect.c | 119 +++++++++++++-----------------
src/test/authentication/t/001_password.pl | 29 +++++++-
2 files changed, 79 insertions(+), 69 deletions(-)