Re: Is my standby fully connected?

I get 1 row, a walreceiver and my slave IP,

i was expecting something like:

 pg_current_xlog_location 
--------------------------0/2000000
(1 row)

When I ran ->               psql -c "SELECT pg_current_xlog_location()" -h192.168.0.10 (primary host)

On Mon, Jun 1, 2015 at 2:04 PM, Guillaume Lelarge <guillaume@lelarge.info> wrote:

Hi,

2015-06-01 19:57 GMT+02:00 Ivann Ruiz <ivann.jprog@gmail.com>:

I just setup my databases and got this LOG:

LOG:  database system was shut down in recovery at 2015-06-01 13:31:21 EDT

LOG:  entering standby mode

LOG:  redo starts at 0/67000278

LOG:  consistent recovery state reached at 0/67000350

LOG:  record with zero length at 0/67000350

LOG:  database system is ready to accept read only connections

LOG:  started streaming WAL from primary at 0/67000000 on timeline 1

Sounds good to me.
 

And it always stays like this, i never get a message like:

LOG:   streaming replication successfully connected to primary

Additionally, i cannot run queries such as:

psql -c "SELECT pg_current_xlog_location()" -h192.168.0.10

...to calculate replication lag, I get the following message:

ERROR: recovery is in progress

HINT: WAL control functions cannot be executed during recovery

Can someone please tell me what is going on?

This is just what it's supposed to be. And it tells you exactly that. You cannot use pg_current_xlog_location() on a slave.

Check pg_stat_replication view on the master.

--

Guillaume.

  http://blog.guillaume.lelarge.info

  http://www.dalibo.com