Re: Synchronizing slots from primary to standby

On Fri, Jan 5, 2024 at 4:25 PM Dilip Kumar <dilipbalaut@gmail.com> wrote:
>
> On Fri, Jan 5, 2024 at 8:59 AM shveta malik <shveta.malik@gmail.com> wrote:
> >
> I was going the the patch set again, I have a question.  The below
> comments say that we keep the failover option as PENDING until we have
> done the initial table sync which seems fine.  But what happens if we
> add a new table to the publication and refresh the subscription? In
> such a case does this go back to the PENDING state or something else?
>

At this stage, such an operation is prohibited. Users need to disable
the failover option first, then perform the above operation, and after
that failover option can be re-enabled.

--
With Regards,
Amit Kapila.