Re: HOT vs freezing issue causing "cannot freeze committed xmax"

Поиск
Список
Период
Сортировка
От Robert Haas
Тема Re: HOT vs freezing issue causing "cannot freeze committed xmax"
Дата
Msg-id CA+TgmoY4691zoMo1nZzxwnJ8t9MX0zHwKSVp2LeL=z=FCBXxYA@mail.gmail.com
обсуждение исходный текст
Ответ на HOT vs freezing issue causing "cannot freeze committed xmax"  (Andres Freund <andres@anarazel.de>)
Ответы Re: HOT vs freezing issue causing "cannot freeze committed xmax"  (Andres Freund <andres@anarazel.de>)
Список pgsql-hackers
On Thu, Jul 23, 2020 at 2:10 PM Andres Freund <andres@anarazel.de> wrote:
> In the case the HOT logic triggers, we'll call
> heap_prepare_freeze_tuple() even when the tuple is dead.

I think this is very bad. I've always been confused about these
comments, but I couldn't quite put my finger on the problem. Now I
think I can: the comments here imagine that we have the option either
to set tupgone, causing the line pointer to be marked unused by an
eventual call to lazy_vacuum_page(), or that we can decline to set
tupgone, which will leave the tuple around to be handled by the next
vacuum.

However, we don't really have a choice at all. A choice implies that
either option is correct, and therefore we can elect the one we
prefer. But here, it's not just that one option is incorrect, but that
both options are incorrect. Setting tupgone controls whether or not
the tuple is considered for freezing. If we DON'T consider freezing
it, then we might manage to advance relfrozenxid while an older XID
still exists in the table. If we DO consider freezing it, we will
correctly conclude that it needs to be frozen, but then the freezing
code is in an impossible situation, because it has no provision for
getting rid of tuples, only for keeping them. Its logic assumes that
whenever we are freezing xmin or xmax we do that in a way that causes
the tuple to be visible to everyone, but this tuple should be visible
to no one. So with your changes it now errors out instead of
corrupting data, but that's just replacing one bad thing (data
corruption) with another (VACUUM failures).

I think the actual correct behavior here is to mark the line pointer
as dead. The easiest way to accomplish that is probably to have
lazy_scan_heap() just emit an extra XLOG_HEAP2_CLEAN record beyond
whatever HOT-pruning already did, if it's necessary. A better solution
would probably be to merge HOT-pruning with setting things all-visible
and have a single function that does both, but that seems a lot more
invasive, and definitely unsuitable for back-patching.

-- 
Robert Haas
EnterpriseDB: http://www.enterprisedb.com
The Enterprise PostgreSQL Company



В списке pgsql-hackers по дате отправления:

Предыдущее
От: Alexey Bashtanov
Дата:
Сообщение: Re: Improve planner cost estimations for alternative subplans
Следующее
От: Robert Haas
Дата:
Сообщение: Re: Default setting for enable_hashagg_disk