I have a process which does backups by mounting a disk into a RAID array,
allowing it to sync, then it must stop the database before detaching it so
as to insure that the DBMS is consistent on the backup disk.
Once detached, Postgres must be restarted, of course......
This process is MUCH faster than dumping the disks to tape and results in a
bootable backup volume - the latter is of great value for disaster recovery!
--
--
Karl Denninger (karl@denninger.net) Internet Consultant & Kids Rights Activist
http://www.denninger.net My home on the net - links to everything I do!
http://scubaforum.org Your UNCENSORED place to talk about DIVING!
http://www.spamcuda.net SPAM FREE mailboxes - FREE FOR A LIMITED TIME!
http://genesis3.blogspot.com Musings Of A Sentient Mind
On Sat, Apr 02, 2005 at 01:50:03AM -0500, Matthew T. O'Connor wrote:
> Why would you run pg_autovacuum from cron?
>
> Karl Denninger wrote:
>
> >Hi folks.
> >
> >There's a problem in the console detach code for pg_autovacuum.
> >
> >"setsid()" is NOT sufficient. Specifically, you must disassociate the
> >control terminal (standard in, out and error) for it to be complete.
> >
> >This causes any attempt to execute pg_autovacuum from the cron to hang the
> >cron processor, stalling it.
> >
> >Find below a diff that fixes the problem and allows proper disassociation:
> >
> >
> >*** pg_autovacuum.c.old Fri Apr 1 21:13:22 2005
> >--- pg_autovacuum.c Fri Apr 1 20:55:41 2005
> >***************
> >*** 196,201 ****
> >--- 196,202 ----
> > daemonize(void)
> > {
> > pid_t pid;
> >+ int i;
> >
> > pid = fork();
> > if (pid == (pid_t) -1)
> >***************
> >*** 219,224 ****
> >--- 220,230 ----
> > fflush(LOGOUTPUT);
> > _exit(1);
> > }
> >+ i = open(NULL_DEV, O_RDWR);
> >+ dup2(i, 0);
> >+ dup2(i, 1);
> >+ dup2(i, 2);
> >+ close(i);
> > #endif
> >
> > }
> >
> >
> >--
> >
> >
>
>
>
> %SPAMBLOCK-SYS: Matched [@postgresql.org], message ok