Re: alter-table-1 isolation test spec contains a duplicate step name

Robert Haas <robertmhaas@gmail.com> writes:
> Commit f14a6bbedb79adce2298d0d4f5e2abe8563e0eca added an isolation
> test, alter-table-1.spec, which reads in part:

> session "s2"
> setup           { BEGIN; }
> step "rx1"      { SELECT * FROM b WHERE a_id = 1 LIMIT 1; }
> step "wx"       { INSERT INTO b VALUES (0); }
> step "rx1"      { SELECT * FROM b WHERE a_id = 3 LIMIT 3; }
> step "c2"       { COMMIT; }

> The step name "rx1" is used twice, a condition the isolation tester
> should probably reject as an error but currently doesn't.

+1 for throwing an error ... this is clearly a mistake.
        regards, tom lane