V16 to V18 Upgrade of Replication Shadow -- Possible to do without a full refresh?
V16 to V18 Upgrade of Replication Shadow -- Possible to do without a full refresh?
Hallo,
I attempted to upgrade a Source and mirror from V16 to V18. The source upgrade went without any glitches.
However the mirror does not like to be upgraded while still in recovery mode. I had to promote it to do the upgrade.
But I did not know how to make the mirror catch up from where it left off. I ended up doing a full refresh and replication ( basically a new replication setup).
What method should I use to make the mirror catch up from where it left off.
Lg
Ram
Freundliche Grüße
i. A. Ramachandran Subramanian
Zentralbereich Informationstechnologie
Alte Leipziger Lebensversicherung a. G.
Hallesche Krankenversicherung a. G.
______________________ ALH Gruppe Alte Leipziger Lebensversicherung a. G., Alte Leipziger-Platz 1, 61440 Oberursel Sitz Oberursel (Taunus) · Rechtsform VVaG · Amtsgericht Bad Homburg v. d. H. HRB 1583 · USt.-IdNr. DE 114106814 Hallesche Krankenversicherung a. G., Löffelstraße 34-38, 70597 Stuttgart Vors. des Aufsichtsrats: Dr. Walter Botermann · Vorstand: Christoph Bohn (Vors.), Dr. Jürgen Bierbaum (stv. Vors.), Robert Gladis, Dr. Jochen Kriegmeier, Alexander Mayer, Christian Pape, Udo Wilcsek Sitz Stuttgart · Rechtsform VVaG · Amtsgericht Stuttgart HRB 2686 · USt.-IdNr. DE 147802285 Beiträge zu privaten Kranken- und Pflegekrankenversicherungen unterliegen nicht der Versicherungsteuer (§ 4 (1) Nr. 5 b VersStG) · Versicherungsleistungen sowie Umsätze aus Versicherungsvertreter-/Maklertätigkeiten sind umsatzsteuerfrei
Alte Leipziger-Platz 1, 61440 Oberursel
Tel: +49 (6171) 66-4882
Fax: +49 (6171) 66-800-4882
E-Mail: ramachandran.subramanian@alte-leipziger.de
www.alte-leipziger.de
www.hallesche.de
Pflichtangaben der ALH Gruppe gemäß § 35a GmbHG bzw. § 80 AktG
Re: V16 to V18 Upgrade of Replication Shadow -- Possible to do without a full refresh?
On Tue, 2026-10-13 at 13:27 +0000, Subramanian,Ramachandran wrote: > I attempted to upgrade a Source and mirror from V16 to V18. The source upgrade went without any glitches. > However the mirror does not like to be upgraded while still in recovery mode. I had to promote it to do the upgrade. > > But I did not know how to make the mirror catch up from where it left off. I ended up > doing a full refresh and replication ( basically a new replication setup). > What method should I use to make the mirror catch up from where it left off. Discard the standby and rebuild it with a new base backup. That's the supported way. Yours, Laurenz Albe