On Fri, Jan 5, 2024 at 5:45 PM Amit Kapila <amit.kapila16@gmail.com> wrote:
>
> On Fri, Jan 5, 2024 at 4:25 PM Dilip Kumar <dilipbalaut@gmail.com> wrote:
> >
> > On Fri, Jan 5, 2024 at 8:59 AM shveta malik <shveta.malik@gmail.com> wrote:
> > >
> > I was going the the patch set again, I have a question. The below
> > comments say that we keep the failover option as PENDING until we have
> > done the initial table sync which seems fine. But what happens if we
> > add a new table to the publication and refresh the subscription? In
> > such a case does this go back to the PENDING state or something else?
> >
>
> At this stage, such an operation is prohibited. Users need to disable
> the failover option first, then perform the above operation, and after
> that failover option can be re-enabled.
Okay, that makes sense to me.
--
Regards,
Dilip Kumar
EnterpriseDB: http://www.enterprisedb.com